|
10AM - TUESDAY - MARCH 22
Preview 10am to 4pm, Monday, March 21
21111 NW Chip Yard Rd, Sheridan, OR
Past Auction held in 2005
Auctioneers note: Auction starts at 10am sharp with major equipment
Display Catalog
Downloadable PDF Catalog
Advance Bid Center
|
|
CHIPPING PLANT
|
- RAMEY pedestal mount hydraulic log loader w/grapple
- 1996 NICHOLSON 22" A5A-LH 6 tool air seal ring debarker, 100 hp AC ring drive, 80 hp feed roll drive, slide out ring, 6'x15' control booth, hydraulic support unit, s/n: 6688
- 1996 NICHOLSON 96" 6 knife horizontal over center feed, horizontal side discharge whole log chipper, hydraulic start assist, 24"x36" throat, (2) 400 hp/1170 rpm/440 volt drives, s/n: S2655R
- BM&M 20'x8' 3 deck chip classifier screen w/drive, s/n: 5649
- WILLIAMS 40S drop feed, bottom discharge hammer hog w/drive, s/n: 13640
- SCHUTTE 90B2, #1 1/2 drop feed, bottom discharge hammer mil, 75 hp
- PEERLESS 30 unit hydraulic hog fuel bin w/15 hp hydraulic unit, 10'x10'x10' surge bin, 2 auger clean out, SKK drive
- 8'x44" scalper screen w/drive
- Hydraulic log splitter w/18' opening, (2) 10' hydraulic rams, diesel fired hydraulic support unit
- PACIFIC fluid systems hydraulic unit w/(4) 50 hp pumps
- QUINCY QNW360-1 75 hp rotary screw air compressor, w/(2) 6'x30" vertical air receiver tanks
- RSE-SIERRA 3000 amp 480Y/277 volt 3 phase ground fault breaker panel
- SQUARE D 6 section, 29 station MCC
- (2) SIEMENS 400 hp reduced voltage starters
- SQUARE D Size 5, (2) SQUARE D Size 4 reduced voltage starters
- (2) SIEMENS 800 amp adjustable trip breakers
- ITE, SIEMENS 600 amp adjustable trip breakers
- CUTLER HAMMER, HITACHI 20 hp adjustable frequency AC motor controllers
- SIXTRACK & DVD chip line programmable digital controllers
- Assortment of stand alone electric boxes, wires and conduit throughout chipping facility
|
|
CHIPPING PLANT CONVEYING EQUIPMENT
|
- 85'x60" radial arm stacker troughing roll belt conveyor w/FALK belt drive, SKK 3 hp/16 1/2 rpm rubber tire travel drive
- 50'x33" wheeled troughing roll belt conveyor stacker
- 35'x18" wheeled belt conveyor stacker w/chevron belt
- 30'x60" troughing roll chipper outfeed belt conveyor, SKK drive
- 60'x36" troughing roll belt conveyor w/chevron belt, SKK drive
- 26'x55" troughing roll belt conveyor w/SKK 7 « hp/100 rpm drive
- 30'x60" troughing roll belt conveyor w/5 hp motor, FOOTE JONES 57.6:1 reducer
- 62'x38" troughing roll belt conveyor w/SKK 7 « hp/68 rpm drive
- 35'x20" OVERS belt conveyor w/SKK drive
- 30' 6 strand H124 chain log deck, log stop and loader, S-drive, 10 hp SKK drive
- 123' WD118 drag chain log haul conveyor w/SKK 15 hp/68 rpm drive
- 80' H112 drag chain log haul conveyor w/SKK 20 hp/45 rpm drive
- 53' H112 drag chain log haul conveyor, S drive, gearhead
- 72' H104 drag chain conveyor w/SKK 7 1/2 hp/68 rpm drive
- 50' H104 drag chain conveyor w/SKK 10 hp/88 rpm drive
- 80' H78 chain conveyor w/flites, SKK drive
|
|
SAWMILL EQUIPMENT
|
- POULSEN 36, 6' traveling horizontal mobile head rig bandmill, 36" diameter wheels, hydraulic strain, 50 hp bandmill drive, 10 hp hydraulic support unit, UNI-OP touch pad controls, forward and reverse saw drive, stationary carriage w/5 position preset setworks, log clamp and turner
- MARATHON 18" sash gang resaw w/powered in and outfeed rollcases, 40 hp saw drive, hydraulic unit
- L&M 8' bar chain lumber package cut-off saw, 15 hp, 27' package rollcase
- (12) 20' green chain lumber stacking rollcases
- SCHURMAN rosser head debarker
|
|
FIREWOOD PROCESSING LINE
|
- RAMEY pedestal mount hydraulic log loader w/grapple
- 14' 5 strand H124 chain log deck w/SKK 10 hp/25 rpm drive
- 22' H132 chain log haul conveyor w/motor, pacific reducer
- 6' bar chain log cut-off saw w/clamp, 30 hp, w/clean-out sawdust conveyor, hydraulic unit
- 12' H78 chain conveyor feeding splitter
- Shop built 6 blade hydraulic splitter w/23" throat
- 24'x18" inclined cleated truck loading belt conveyor w/hydraulic drive
- Line hydraulic support unit w/(2) 50 hp pumps
|
|
ROLLING STOCK
|
- THUNDERBIRD 636DL crawler stroke delimber w/DENARCO head, s/n: 9081
- JOHN DEERE 992LC crawler log loader, YOUNG swivel grapple, s/n: CK992DL005081
- LINKBELT LS5800TL crawler log loader, DETROIT diesel, swivel grapple, s/n: 41G61003B
- CATERPILLAR 950 articulated rubber tire front end loader, diesel, powershift trans, chip bucket
- TEREX 72-71B articulated rubber tire front end loader, DETROIT diesel, log forks
- TEREX 72-61AA articulated rubber tire front end loader, DETROIT diesel, log forks
- TROJAN 4000 articulated rubber tire front end loader, CUMMINS NTC335 diesel, chip bucket, s/n: 76-4156
- 1980 PETERBILT 351A tandem axle chip truck, CUMMINS diesel, FULLER transmission, 20'x8'x7' hydraulic dump box, VIN# K5666
- 500 gallon single axle fire trailer w/tank, pump and reel
- MAR 8000 lb capacity log trailer loader, fork mounted work platform, 500 gallon fuel tank w/ stand
|
|
MISCELLANEOUS EQUIPMENT
|
- 30'x40' wood and steel framed roof structure, 14'x26' welded steel framed chipper building, MILLER SRH333 DC welder, NIELSEN chain saw sharpener, JET 14" 5 speed drill press, DAYTON 1 hp double end grinder, cart mounted pneumatic lube pump, oxy-acetylene set, steel table w/vise, mill parts, more
- NOTE: A sale of the entire facility is pending. If the sale does not occur by March 11, 2005, the auction will proceed as scheduled. Please call Andy Taylor, 503-463-4444 for additional information.
|
|
TERMS & CONDITIONS
|
- 10% BUYERS PREMIUM
- PAYMENT
: Full payment must be made by no later than 4pm, Wednesday, March 23.
- A 25% deposit is required by the close of business, auction day.
- Cash, cashiers check, Master & Visa Cards, wire transfers only. Personal or company checks accepted ONLY with bank letter of guarantee.
- Absentee bids accepted with 25% deposit
- REMOVAL: No purchase may be removed during the auction unless otherwise announced by the auctioneer. Equipment removal schedule announced on auction day.
- Announcements made by the auctioneer at the time of sale take precedence over printed matter.
- Auctioneer reserves the right to sell accessories, parts or attachments on a separate and/or aggregate basis.
- Due to safety & insurance reasons, persons under 12 not admitted.
- Washington Auctioneers License #48
|
|
DRIVER DIRECTIONS
|
- From McMinnville, OR, take Hwy. 18 West to Hwy. 18/Sheridan Business Loop(#exit 34).
- Drive approximately 2.8 miles through Sheridan to NW Chip Yard Rd.
- Turn right on NW Chip Yard Rd. and drive to the auction site.
WATCH FOR AUCTION SIGNS
FOOD SERVICE AVAILABLE AT THE AUCTION SITE
|
Home | About Us | Auction Schedule | Immediate Sales | Email Signup | Map | Past Auctions | Registration Form | Advanced Bid Overview | Terms & Conditions | Best of 2000-2004 Auctions
James G. Murphy Co.
Commercial / Industrial / Real Estate Auctioneers
P.O. Box 82160 - 18226 - 68th Ave. N.E.
Kenmore, Washington 98028
(425) 486-1246 or Toll Free 1-800-426-3008
Fax: (425) 483-8247
Oregon address & phone:
105 McNary Estates Dr. N
Keizer, OR 97303
phone: (503) 463-4444
fax: (503) 463-1554
Copyright©1997-2005 James G. Murphy Co.
All rights reserved worldwide
|
|
|
